Skip to Content
  1. All products
  2. AUTOMATIC CYLINDERS
  3. BURG-WÄCHTER ZBK 73 CAM LOCK
  4. AUTOMATIC CYLINDERS
Pricelist: 00. Publieke prijslijst Pricelist
Pricelist: 00. Publieke prijslijst Pricelist

BURG-WÄCHTER ZBK 73 CAM LOCK

17.16 EUR 17.16

20.76 € 20.76 €

17.16 € 17.16 € excl. VAT

Stock: 0 Units
Location(s): None found

  • Outer diameter Ø (mm)
  • Inner diameter Ø (mm)
  • Distance of flat sides (mm)
  • Distance from housing to lip (mm)
  • Type of closure
Add to cart
Add to wishlist
Contact Us
Outer diameter Ø (mm): Ø 22.5
Inner diameter Ø (mm): Ø 19.4
Distance of flat sides (mm): 16.4
Distance from housing to lip (mm): 16
Type of closure: Keyed different (KD)
Article Number: ZBK 73
Barcode: 4003482223901

CYLINDER ZBK 73: REPLACEMENT FOR BRABANTIA LETTERBOXES (SHEET METAL MODELS)

Your letterbox lock needs to be replaced? No problem with the matching letterbox lock as an inexpensive replacement part. BURG-WÄCHTER offers separate letterbox cylinders for simple and quick self-installation. The letterbox cylinders can be used on many letterboxes of different makes without any problems. Not only from the house of BURG-WÄCHTER.

INSTALL CYLINDER ZBK 73 IN JUST A FEW STEPS

The letterbox lock ZBK 73 is suitable for sheet metal letterboxes made by Brabantia. After a few simple steps, your letterbox is ready for use again with the new cylinder ZBK 73. Assembly tip: Note that the key is not removed during the assembly process. 

1. Technical data sheet for letterbox cylinder ZBK 73 from BURG-WÄCHTER: 

It is very important to maintain your lock properly, especially if it is exposed to the elements of nature a lot. Dirt and corrosion can build up, especially during cold and inclement weather. Therefore, we recommend lubricating your door lock at least twice a year or ideally at every seasonal change. 
To make sure your lock runs smoothly again, we recommend using lubricants such asWD-40 WHITE LITHIUM SPRAY GREASE. The correct use of these oils is essential.

​In general, there are two solutions for lock maintenance: prevention/protection and troubleshooting. 

If a lock is difficult to open, it could be due to two reasons: 
​
​1. The key and lock are not yet properly matched, this is common with a new lock

​​2. There is dirt build-up or rust in the lock

In these cases, we recommend using WD-40 WHITE LITHIUM SPRAY GREASE to solve the problem. This will prevent rust from forming in the lock. However, it is important that you apply the oil in the right place in the lock so that the WD-40 gets to the moving parts to ensure proper lubrication.